Conjoined Skull Succulent Planter

With a little lapse of attention while printing our Skull Succulent Planters, we had the temperature a little too high and they ended up fusing together. Instead of three planters coming out we had one plus a conjoined skull. While we threw out the manual already, we do remember a warning that this could happen. Oh well. Our failure is everyone else’s gain as we have no choice but to sell these oddities or else we will just be dwelling in our overwhelming shame from the simple mistake. There is also a 5mm (1/5″) drainage hole in the bottom rear of the planter.

* Plants are not included

Buy on Etsy
Buy on Etsy
Buy on Amazon
Coming Soon!

The size of the skull is approximately 100x110x73mm (3.93 x 4.33 x 2.87 inches) with a volume of 180ml (3/4 cup) and will comfortably house a small to medium sized succulent. There is a 5mm (1/5″) drainage hole in the bottom rear of the planter.

Layer by layer this skull is 3D printed using PLA (polylactic acid) which is a biodegradable and bioactive thermoplastic aliphatic polyester derived from renewable resources, such as corn starch. It takes just over 15 hours to print each planter followed by removing the supports created during the printing process.

Each conjoined skull succulent planter is $17.50 regardless of colour that you choose.

The 3D printing process is not perfect so there may be blemishes in the surface finishes and visible layer lines. Items will not be exactly as pictured and as much as we try to take colour accurate photos, the colour may be slightly different than viewed on your screen.