Coinjoined Skull Succulent Planter

  • $20.00
    Unit price per 


With a little lapse of attention while printing our Skull Succulent Planters, we had the temperature a little too high and they ended up fusing together. Instead of three planters coming out we had one plus a conjoined skull. While we threw out the manual already, we do remember a warning that this could happen. Oh well. Our failure is everyone else's gain as we have no choice but to sell these oddities or else we will just be dwelling in our overwhelming shame from the simple mistake.
* Plants are not included

Size
The size of the skull is approximately 100x110x73mm (3.93 x 4.33 x 2.87 inches) with a volume of 180ml (3/4 cup) and will comfortably house a small to medium sized succulent.

Materials & Process
Layer by layer this skull is 3D printed using PLA (polylactic acid) which is a biodegradable and bioactive thermoplastic aliphatic polyester derived from renewable resources, such as corn starch. It takes just about 16 hours to print each planter.

Disclaimer
The 3D printing process is not perfect so there may be blemishes in the surface finishes and visible layer lines. Items will not be exactly as pictured and as much as we try to take colour accurate photos, the colour may be slightly different than viewed on your screen.

FREE LOCAL PICKUP IN TORONTO
Enter coupon code TORONTO at checkout and you will be sent the local pickup address in the Cabbagetown - Leslieville - Regent Park - Cork Town - Distillery District area of Toronto, Ontario.

Materials: PLA, Polylactic Acid, EcoTough.


We Also Recommend


Customer Reviews

Based on 8 reviews Write a review