PRODUCT DETAILS
With a little lapse of attention while printing our skull succulent planters, we had the temperature a little too high and they ended up fusing together. Instead of two planters coming out, we were met with one creepy conjoined skull that wouldn't stop staring at us! While we threw out the printer manual already, we do vaguely remember a warning that this could happen. Oh well. Our failure is everyone else's gain as we have no choice but to sell these oddities or else we will just be dwelling in our overwhelming shame from the simple mistake.
Choose your skull colour from our entire lineup, and give it a fun and spooky hairstyle with the plants of your choice. Then choose how much drainage your plants (or other uses) require -- no drainage (no holes), light (1 rear hole), or heavy drainage (3 holes).
* Plants are not included
💀 Size
The skulls are approximately 3x4x3 inches (110x100x74mm) with a volume of about 3/4 cup (180ml) and weigh about 3.5oz (100g). They will comfortably house a small to medium-sized succulent or about 52 marbles. If selected, the drainage holes are 1/5" (5mm) and located in the planter's bottom rear.
💀 Materials
These skulls are 3D printed using PLA, a biodegradable and bioactive thermoplastic aliphatic polyester derived from renewable resources such as corn starch and sugar cane. Our test planters have been sitting on our patio for over 5 years now with no degradation in quality; through the freezing cold of Canadian winters and the blazing sun of our summers.
⚠️ Disclaimer
The 3D printing process is not perfect, so there may be blemishes in the surface finishes and visible layer lines. Items will not be exactly as pictured, and as much as we try to take color-accurate photos, the color may be slightly different from what is viewed on your screen.
